The Gate drivers in modern power converters which use the power IGBT must be provide several main operations such as electrical isolation, current amplifying, and protection against overcurrent and overvoltage conditions. This paper describes such a new circuit which is More
The Gate drivers in modern power converters which use the power IGBT must be provide several main operations such as electrical isolation, current amplifying, and protection against overcurrent and overvoltage conditions. This paper describes such a new circuit which is made using SMD devices suitable for driving the high and medium power IGBTs. This driver includes an isolated switching power supply, buffer circuits, and several protection circuits. It can operate by an input signal at TTL level and %50 duty cycle and is able to work up to 6A peak current.
Manuscript profile
In this paper voltage source converter based HVDC (VSC-HVDC) is used for power transmission in asynchrony distribution systems. Direct power control (DPC) of three-phase space vector modulation (SVM) is employed for this control scheme. It is economically motivated to r More
In this paper voltage source converter based HVDC (VSC-HVDC) is used for power transmission in asynchrony distribution systems. Direct power control (DPC) of three-phase space vector modulation (SVM) is employed for this control scheme. It is economically motivated to replace the AC line voltage sensors with a virtual flux (VF) estimator. The control system is resistant to the majority of line voltage disturbances using by the idea of virtual flux. It is also effective to damp system oscillations and enhance power quality when power flow is reversed. Superior advantages of this method are good dynamic response and unity power factor of rectifier.
Manuscript profile
Bearing current in inverter-fed induction motors can result in premature bearing failure. This paper gives a detailed analysis of common mode voltage as the main source of bearing currents. Moreover, it presents an algorithm to reduce the common mode voltage in multilev More
Bearing current in inverter-fed induction motors can result in premature bearing failure. This paper gives a detailed analysis of common mode voltage as the main source of bearing currents. Moreover, it presents an algorithm to reduce the common mode voltage in multilevel DTC drive. Based on the given analysis, the common mode voltage is reduced to about 33 percent of the initial value. The simulation results in MATLAB/SIMULINK confirm the capability of the algorithm in common mode voltage reduction without degrading the electromagnetic torque and the speed response. The results of real world experiments using TMS320F2812 DSP processor are also provided.
Manuscript profile
High voltage chargers are being used in the equipments such as electrical vehicles, uninterruptible power supplies and aircrafts. The converter introduced here is based on bi-directional boost topology. The output voltage of batteries set is larger than the input source More
High voltage chargers are being used in the equipments such as electrical vehicles, uninterruptible power supplies and aircrafts. The converter introduced here is based on bi-directional boost topology. The output voltage of batteries set is larger than the input source voltage amplitude, and this converter can transfer the energy both from the source to the batteries bank and vice versa. Input source voltage is sine wave and the output voltage is DC. Both conversion of AC-to-DC and DC-to-DC is performed in one stage and the control scheme of switches is based on hysteric control method to achieve the unity power factor. One can use the electrical equations presented here to define the converter and EMC filter elements value. Finally, simulation results performed on a typical converter show the control method authenticity and effectiveness of the analyses presented here. Also some suggestion for the future works is proposed.
Manuscript profile