In this paper, a novel structure and a control method to improve the performance of inductive heating circuits is proposed. In the presented structure, with the combination of the performance of a half-bridge resonant converter with voltage-boost capability, the reducti More
In this paper, a novel structure and a control method to improve the performance of inductive heating circuits is proposed. In the presented structure, with the combination of the performance of a half-bridge resonant converter with voltage-boost capability, the reduction in output efficiency at low power and at high power is compensated to an acceptable level. The use of the low number of switches and diodes, the use of the high-quality capacitors with low capacities, good quality of the input current and also high power factor ensures the proper operation of the proposed converter. The switching of high frequency switches in the proposed structure is carried out as soft-switching where resulting in very low switching losses. In this converter, the design of the input filter in order to prevent the effects of electromagnetic interference has been prepared. Finally, to demonstrate the proposed structure operation, the simulation and experimental results are presented.
Manuscript profile
A step-down converter based on buck and buck-boost converters with a loss reduction technique is proposed in this paper. Utilizing non-electrolytic capacitors in the implementation of the proposed converter has resulted in an increase in circuit life and a reduction in More
A step-down converter based on buck and buck-boost converters with a loss reduction technique is proposed in this paper. Utilizing non-electrolytic capacitors in the implementation of the proposed converter has resulted in an increase in circuit life and a reduction in weight and volume. This paper compares the proposed converter to other buck converters. To increase the output efficiency of the converter in comparison to other structures, a new method based on determining the working duty-cycles has been employed to reduce the losses of the converter, resulting in an increase in the converter's output efficiency. In order to demonstrate the differences in efficiency between the proposed method and the conventional method, the efficiency of the converter has been calculated using real-world conditions and the output loss results have been compared. In addition, the proposed converter has a common ground with the input source and has a suitable reduction gain. Finally, this converter has been implemented as a PCB and tested with 100 watts of output power.
Manuscript profile
