New Structure of Wind-PV Farm with Improved Performance under Voltage and Frequency Fault Conditions
Subject Areas : electrical and computer engineering
Mehrdad
Tarafdar Hagh
1
Farshid
Najaty Mazgar
2
3
Keywords: PVFIG wind turbineLVRTFrequency support,
Abstract :
In this paper a new structure for wind – PV farm is proposed. The PV arrays and DC loads are capable to connect to the proposed structure. In the proposed structure each DFIG wind turbine is connected to the AC grid through its stator windings and has a connection to a common DC link via its rotor side converters. The proposed structure uses a high power grid side converter and an energy storage system for entire wind – PV farm. The converter power loss decrease and lifetime increase of power switches are some advantages of the proposed structure under normal operation conditions. The proposed structure with the coordinated power control of DFIG wind turbines, the ESS and PV arrays improves the low voltage ride-through capability under-voltage fault conditions and enhances the frequency response of the wind farm under frequency faults. The proposed structure is simulated in MATLAB/ Simulink software and the results are presented. Furthermore, an experimental setup is provided to test the operation of the proposed structure.
[1] H. Long, M. Eghlimi, and Z. Zhang, "Configuration optimization and analysis of a large scale PV/wind system," IEEE Trans. on Sustainable Energy, vol. 8, no. 1, pp. 84-93, Jan. 2017.
[2] E. E. ENTSO-E, Network Code for Requirements for Grid Connection Applicable to All Generators (NC RfG), Mar. 2013.
[3] -, FERC Order No. 819: Third-Party Provision of Primary Frequency Response Service, 2015. Available: http://www.ferc.gov/whatsnew/commmeet/2015/111915/E-1.pdf
[4] S. Tohidi and M. I. Behnam, "A comprehensive review of low voltage ride through of doubly fed induction wind generators," Renew. Sustain. Energy Rev., vol. 57, pp. 412-419, May 2016.
[5] T. D. Vrionis, X. I. Koutiva, and N. A. Vovos, "A genetic algorithm-based low voltage ride-through control strategy for grid connected doubly fed induction wind generators," IEEE Trans. on Power Sys., vol. 29, no. 3, pp. 1325-1335, Dec. 2014.
[6] H. Mahvash and S. A. Taher, "A look-up table based approach for fault ride-through capability enhancement of a grid connected DFIG wind turbine," Sustainable Energy, Grids and Networks, vol. 10, pp. 128-140, May 2017.
[7] C. Tang, Y. Chen, and Y. Chen, "PV power system with multi-mode operation and low-voltage ride-through capability," IEEE Trans. on Industrial Electronics, vol. 62, no. 12, pp. 7524-7533, Dec. 2015.
[8] F. Lin, K. Lu, T. Ke, B. Yang, and Y. Chang, "Reactive power control of three-phase grid-connected PV system during grid faults using Takagi-Sugeno-Kang probabilistic fuzzy neural network control," IEEE Trans. on Industrial Electronics, vol. 62, no. 9, pp. 5516-5528, Sept. 2015.
[9] L. Yang, Z. Xu, J. Østergaard, Z. Y. Dong, and K. P. Wong, "Advanced control strategy of DFIG wind turbines for power system fault ride through," IEEE Trans. Power Syst., vol. 27, no. 2, pp. 713-722, Dec. 2012.
[10] M. Bongiorno and T. Thiringer, "A generic DFIG model for voltage dip ride-through analysis," IEEE Trans. on Energy Conversion, vol. 28, no. 1, pp. 76-86, Jan. 2013.
[11] D. Xie, Z. Xu, L. Yang, J. Ostergaard, Y. Xue, and K. P. Wong, "A comprehensive LVRT control strategy for DFIG wind turbines with enhanced reactive power support," IEEE Trans. Power Syst., vol. 28, no. 3, pp. 3302-3310, Feb. 2013.
[12] A. M. A. Haidar, K. M. Muttaqi, and M. T. Hagh, "A coordinated control approach for dc link and rotor crowbars to improve fault ride-through of dfig-based wind turbine," IEEE Trans. Ind. Appl., vol. 53, no. 4, pp. 4073-4086, Mar. 2017.
[13] A. D. Falehi and M. Rafiee, "LVRT/HVRT capability enhancement of DFIG wind turbine using optimal design and control of novel PID-AMLI based DVR," Sustainable Energy, Grids and Networks, vol. 16, pp. 111-125, Dec. 2018.
[14] L. Chen, et al., "Combined use of a resistive SFCL and DC-link regulation of a SMES for FRT enhancement of a DFIG wind turbine under different faults," IEEE Trans. Appl. Supercond., vol. 29, no. 2, pp. 1-8, Nov. 2019.
[15] X. Y. Xiao, R. H. Yang, X. Y. Chen, and Z. X. Zheng, "Integrated DFIG protection with a modified SMES-FCL under symmetrical and asymmetrical faults," IEEE Trans. Appl. Supercond., vol. 28, no. 4, pp. 1-6, Feb. 2018.
[16] H. Choi, I. Jeong, S. Park, and H. Choi, "Characteristics of superconducting coil-type DC fault current limiter to increase stability in the grid connection PV generation system," IEEE Trans. on Applied Superconductivity, vol. 28, no. 3, Article no.: 5600904, 4 pp., Apr. 2018.
[17] A. Benali, M. Khiat, T. Allaoui, and M. Denaï, "Power quality improvement and low voltage ride through capability in hybrid wind-PV farms grid-connected using dynamic voltage restorer," IEEE Access, vol. 6, pp. 68634-68648, Nov. 2018.
[18] N. Mahmud, A. Zahedi, and A. Mahmud, "A cooperative operation of novel PV inverter control scheme and storage energy management system based on ANFIS for voltage regulation of grid-tied PV system," IEEE Trans. on Industrial Informatics, vol. 13, no. 5, pp. 2657-2668, Oct. 2017.
[19] Y. Liu, L. Jiang, J. S. Smith, and Q. H. Wu, "Primary frequency control of DFIG-WTs using bang-bang phase angle controller," IET Gener. Transm. Distrib., vol. 12, no. 11, pp. 2670-2678, Jun. 2018.
[20] W. J. Lee, H. Xie, C. Yue, J. Wen, and L. Miao, "Coordinated control strategy of wind turbine generator and energy storage equipment for frequency support," IEEE Trans. Ind. Appl., vol. 51, no. 4, pp. 2732-2742, Jan. 2015.
[21] P. Iurilli, C. Brivio, and M. Merlo, "SoC management strategies in battery energy storage system providing primary control reserve," Sustainable Energy, Grids and Networks, vol. 19, pp. 1-11, Sept. 2019.
[22] B. Craciun, T. Kerekes, D. Sera, and R. Teodorescu, "Frequency support functions in large PV power plants with active power reserves," IEEE J. of Emerging and Selected Topics in Power Electronics, vol. 2, no. 4, pp. 849-858, Dec. 2014.
[23] R. Mohanty and A. K. Pradhan, "DC ring bus microgrid protection using the oscillation frequency and transient power," IEEE Systems J., vol. 13, no. 1, pp. 875-884, Mar. 2019.
[24] ABB, ABB Wind Converters, ACS880 Wind Turbine Converters, 800 kW to 8 MW, Data Sheet, Dec. 2016.
[25] M. Liserre, R. Cardenas, M. Molinas, and J. Rodriguez, "Overview of multi-MW wind turbines and wind parks," IEEE Trans. on Industrial Electronics, vol. 58, no. 4, pp. 1081-1095, Apr. 2011.
[26] G. Ding, et al., "Adaptive DC-link voltage control of two-stage photovoltaic inverter during low voltage ride-through operation," IEEE Trans. on Power Electronics, vol. 31, no. 6, pp. 4182-4194, Jun. 2016.
[27] L. Miao, J. Wen, H. Xie, C. Yue, and W. Lee, "Coordinated control strategy of wind turbine generator and energy storage equipment for frequency support," IEEE Trans. Ind. Appl., vol. 51, no. 4, pp. 2732-2743, Jul. 2015.
[28] O. S. Senturk, L. Helle, S. Munk-Nielsen, P. Rodriguez, and R. Teodorescu, "Converter structure-based power loss and static thermal modeling of the press-pack IGBT three-level ANPC VSC applied to multi-MW wind turbines," IEEE Trans. on Ind. Appl., vol. 47, no. 6, pp. 2505-2515, Sept. 2011.
[29] Hitachi Power Semiconductor Device, High Voltage IGBT Module No. IGBT-HI-00002, Application Manual, 2009.
[30] S. Mohsenzade, M. Zarghani, and S. Kaboli, "A high voltage series stacked IGBT switch with active energy recovery feature for pulsed power application," IEEE Trans. on Ind. Elec., vol. 67, no. 5, pp. 3650-3661, Jun. 2019.
[31] H. Li, et al., "Thermal coupling analysis for a multi-chip paralleled IGBT module in a doubly fed wind turbine power converter," IEEE Trans. Energy Convers., vol. 8969, pp. 173-183, Jan. 2016.
[32] K. Vechalapu, A. Negi, and S. Bhattacharya, "Performance evaluation of series connected 15 kV SiC IGBT devices for MV power conversion systems," in Proc. IEEE Energy Conversion Congress, ECCE’16, 8 pp., Milwaukee, WI, USA, 18-22 Sept. 2016.
[33] S. Madhusoodhanan, et al., "Solid-state transformer and MV grid tie applications enabled by 15 kV SiC IGBTs and 10 kV SiC MOSFETs based multilevel converters," IEEE Trans. on Ind. Appl., vol. 51, no. 4, pp. 3343-3360, Mar. 2015.